Trailer Electrical Converter, 24 Volt Military to 12 Volt Civilian w/ Electric Brake Pass Through, UTC 2412RVEB

Trailer Electrical Converter, 24 Volt Military to 12 Volt Civilian w/ Electric Brake Pass Through, UTC 2412RVEB
Item# UTC2412RVEB

Product Description

Trailer electrical interface converts from 24 volt Military standard (MS75021-1) connector to 12 volt civilian standard (Pollack 12-707) 7 way connector. This allows towing a civilian trailer with a Military vehicle. This model features a pass through connection on the electric brake wire for compatibility with cab mounted 12 volt brake controllers. Converter is made in USA. We are an authorized factory distributor and the product includes a 2 year manufacture's warranty.

UTC 2412RVEB Specifications:
Inputs: 21-29 Volts DC (will withstand 36 Volts DC)
Input current: 45 Amps max total
Number of converters per unit: 4 (3 control basic lights, extra 1 allow for aux uses, see i/o listing below)
Output: 13.6 Volts DC +/- 0.3 VDC
Output current capability on each of the 3 main converters: 10 Amps/15 Amp Surge.
Output current capability on auxiliary converter: 15 Amps
Output power: 800 Watts max total
Overload and short circuit protection: electronically controlled
Efficiency: 90 percent typical
Aluminum housing with steel end caps.
Mounting holes (6) for 1/4 inch hardware.
Overall Length: 21-1/4 inches
Overall Height: 4-3/4 inches
Overall width: 8-11/16 inches
Sealed case protects against water and dust.

Input connector configuration:
A- not used
B- left turn/brake
C- not used
D- ground
E- tail light/clearance light
F, H - not used
J- right turn/brake
K- Electric brakes (signal from cab mounted controller)
L- ground
M- aux 24 volt input
N- not used

Output connector configuration:
1 (white) - ground
2 (blue) - Electric brakes - pass through from "K" on input connector
3 (green) - tail light/clearance light
4 (black) - aux 12 volt out
5 (red) - left turn/brake
6 (brown) - right turn/brake
7 - not used

Note: unit is not a trailer brake controller. Electric brakes, if used, must have their own controller installed. The controller must be connected to the vehicle's trailer receptacle socket terminal "K.

To interface an electric brake controller with a military vehicle use relay interface p/n 4M-6003 and power converter model 362.

See p/n PK12716 to change from the output 7 way to the 4 way plug.
See p/n 7728814 or 7728811 for intervehicular input cable.
See p/n MS75020-2 for mating input plug.

20 lb shipping weight